100 Ski Jacket

Main fabric: 100.0% Polyester ; Main lining: 100.0% Polyester ; Padding: 100.0% Polyester ; Secondary lining: 100.0% Polyamide ; Coating: 100.0% Polyurethane

To help keep you warm, we use recycled padding insulation (3.5 oz/m² on the arms and 5.3 oz/m² on the body). This synthetic polyester-based fill traps more or less air, depending on the size of its fibers, in order to insulate you from the cold.

As well as its filling, your jacket's partially taped seams, collar and cuff tightening offer better protection against the cold and damp for a warmer feeling.

The coating is a waterproofing material spread over the inner surface of a fabric. It prevents water from seeping into the garment but allows the water vapor produced by the body's physical activity to escape. So you stay dry for greater comfort while practicing your sport.

The resistance of a fabric to water pressure is expressed in terms of the height in mm of a water column that can be supported by the fabric (test based on the ISO 811 standard). The higher the pressure, the more waterproof the fabric. A component with a waterproof rating of 3000 mm can therefore withstand the pressure exerted by a 3000 mm column of water.

The 100 jacket has been developed with a sophisticated component and assembly that prevent water from entering and reduce wind chill to help you cope with the weather conditions (rain, snow, wind, etc.). We validated the waterproofing of this product in the field in various weather conditions for several days.

The water-repellent property of a fabric is its capacity to make water run off its surface without absorbing it. This jacket features water-repellent components that extend its weather resistance. The fabric is made water-repellent by treating its outer surface. However, this property may deteriorate with use.

Bear in mind that the water-repellent feature can be reactivated. To do this, put the jacket in the dryer on a synthetic cycle for 10 to 15 minutes.You can also use a waterproofing spray (sold in our stores): spray the product evenly over the entire garment and allow to dry for 10 to 12 hours.

This garment wicks away the water vapor produced by your body when exercising. To find out if a fabric is breathable, we measure its total evaporative resistance RET (test based on the ISO 11092 standard). The lower the RET, the more breathable the fabric. The 100 jacket has an RET of 12. However, it's the technical solutions (zippers, vents, mesh) Wedze uses that limit the condensation inside the garment and maximize breathability.

Regular fit. The sides of the jacket hang down straight and remain parallel without conforming to the shape of bust. The interior volume means this jacket can be worn in combination with a 1st and 2nd technical layer.

All Wed'ze products are created, designed, and developed in the Mont Blanc Valley. They are then tested under the same conditions as you would experience in real-life use (snow, cold, powder snow, etc.) The design teams make sure that the program for which the product is designed and developed, corresponds perfectly to its use in the field.

Store on a hanger and do not fold, as this can damage the fabric coating. Dry thoroughly before storing in a dry and well-ventilated place.

Imported