Radbug 500 Bodyboard Biceps Coiler leash w/ Plug

Main fabric: 80.0% Thermoplastic Polyurethane, 20.0% Steel ; Wrist: 80.0% Rubber, 20.0% Polyester

- Novices: Up to the navel, no fins, small waves < 20”, propulsion by pushing your feet on the ground and riding the wave to the shore. For a 1st wave-riding experience (bodyboard with grips).- Beginner: Gentle turns in waves up to 40”, propulsion with fins. A must for learning to bodyboard.- Intermediate: Waves up to 5', more speed, and the beginning of tricks (360°, El Rollo, etc.).- Advanced: All types of waves, command of tricks, even aerial: ARS, 360°, tube...

This leash attaches to the bodyboard using the leash plug provided or already present on your bodyboard.To use it, place the bracelet above the elbow on the side that you prefer. Tighten the strap with your other hand and secure it with the rip-tab strap.Note: The cuff of this leash is too wide to be attached at the wrist.

The materials chosen for this leash provide good resistance in waves of less than 5'. However, be careful not to put yourself in a dangerous situation due to a broken leash. Always check the condition of your leash before the session and avoid prolonged UV exposure. Systematically rinse it and store it in a dry place in the shade.

The benefit of a spiral leash is that it is compact and does not get in your way during practice. If this leash is stored for too long in a stretched position, the coil will relax and it will no longer be compact. It is therefore recommended to attach the adjustable end to the cord connected to the plug, using it and the rip-tab strap between each session. This will prevent the leash from stretching when not in use. See the illustration photo provided.

To install the plug on a bodyboard, first identify the correct location: Between 4” and 6” from the nose of the board and far enough away from any stringers. If the board has 2 stringers, the plug must be central. If the board has a single stringer, the plug must be offset at least 2” from the middle of the board, on the right if you wear your leash on the right, or vice versa.

At the desired location, pierce a hole using a large Phillips screwdriver from below. (If you pierce from the top, you could damage the slick by lifting it off).Insert the 2 parts of the plug one after the other, with the screw at the bottom.Screw it in using a coin until the slick warps slightly.

Bodyboarding is a fantastic sport, but one that requires everyone to respect certain basic rules to preserve the safety and enjoyment of all. 1- Ask about and observe the characteristics of the spot: current, rocks, tides, the size of the waves and the crowds, etc. 2- Don’t overestimate your level, and go for an easier spot if your skills aren’t on par with the conditions.3- Use suitable equipment: Leash, fins, and board in good condition, suitable wetsuit.

4- Respect the rules of right of way on the waves: Right of way goes to the person closest to the peak.5- Follow the direction of the wave when moving toward the peak to keep from cutting another boarder off.6- Use fins if the water is above your hips.7- If you’re not using fins, it’s recommended you keep to a supervised area. Lifeguards can tell you where these are.8- Bodyboard in a group.

Radbug is the Decathlon brand dedicated to bodyboarding and bodysurfing.Our ambition is to enable the greatest number of people of people to enjoy the incredible sensations you feel when bodyboarding and bodysurfing.This sensation of gliding when in contact with the wave is pure, exhilarating, and addictive. We have set ourselves the mission of enabling everyone to get started and make progress by offering products that are easy to use and innovative.

Developed and tested by our bodyboard-loving design teams in Hendaye, France. The materials used for this product are laboratory-tested to ensure the best possible quality and durability.

Rinse and dry in a dry and well-ventilated place after use.

Imported