Men's Sailing Oilskin 500

WATERPROOFING

- Dual-layer hydrophilic fabric
- >8000 mm of water pressure.
- Fully taped seams.
- Two-way adjustable hood.
- Sleeve cuffs adjustable by hook and loop fastener strips.
- Central opening features an internal flap with a drainage channel for optimal waterproofing.
- Tested under a simulated heavy rain shower (119 gal/hr/sqm) for 4 hours

BREATHABILITY

RET <12: very breathable.

To find out whether a fabric is breathable, we measure its evaporative resistance, or RET, (test based on the ISO 11092 standard). It is its ability to allow the water vapor produced by the body during exercise to escape.

COMFORT

- Two-way adjustable hood.
- Adjustable jacket hem.

REFLECTIVE

- 2 shoulder patches
intensifying light sources.

RESISTANCE TO WEAR

- Injected plastic central zipper resistant to salt oxidation.

HOW TO REACTIVATE THE JACKET'S WATER REPELLENCY \nstep 1: before washing

Close all zippers and flaps and remove any parts of the garment that cannot be washed. Also remember to loosen the straps and elastic parts and empty the pockets.
Then turn the garment inside out to wash it.

HOW TO REACTIVATE THE JACKET'S WATER REPELLENCY \nstep 2: washing

You can wash your jacket on a synthetic cycle at 86°F or 104°F with your usual detergent. Do not use fabric conditioner, which could damage the existing performance of the garment, or bleach.

Also take care not to bend your jacket too much when you place it in the washing machine and do not overload your machine.

Very important: select a thorough rinse or double rinse to completely remove all detergent residue.

HOW TO REACTIVATE THE JACKET'S WATER REPELLENCY \nstep 3: drying

Drying is a crucial phase in reactivating the water repellent treatment.
We recommend that you lay your jacket flat on a clothes rack and leave it out to dry in the open. Caution: never dry your jacket directly on a radiator.

Then place it in the tumble dryer on a short synthetics cycle, i.e. 10 to 15 minutes, before turning it back the right way round.

HOW TO REACTIVATE THE JACKET'S WATER REPELLENCY

If, despite this procedure of washing and thorough rinsing followed by gentle drying in a tumble dryer, the drops of water no longer run off the surface of your jacket, we recommend that you "re-waterproof" it using a waterproofing spray or detergent sold in our stores.

Score to compare the environmental impact of products

The environmental impact of the product is calculated over its entire life cycle and with different indicators. An overall score (ABCDE) is attributed to help you easily identify the products with the best environmental performance by comparing products of the same type with one another (T-shirts, pants, backpacks, etc.).

Decathlon chose to apply this voluntary environmental labeling scheme.
For more information, visit: http://sustainability.decathlon.com/

Composition

Main fabric : 100.0% Polyamide \r\nMain lining : 100.0% Polyester cationic\r\nSecondary lining : 100.0% Polyamide

Storage Instructions

Store in a dry place, but do not leave your garment on a heat source such as a radiator, as this may damage the breathable membrane or coating.

Care Instructions

Machine wash your Offshoroa Men's waterproof oilskin at 86°F. Turn inside-out and fasten hook and loop fasteners. Choose a long rinse and gentle spin cycle. Line dry if possible. Occasional tumble drying on low for a short period of time will improve the water repellent treatment. To reactivate the water repellent treatment, you can also warm iron the fabric up to a maximum temperature of 284°F or apply the Tribord re-waterproofing spray

Guarantee

2 Years

Origin

Imported

Model Code

8330287