Men's Race Sailing Overalls designed for regular yacht racers sailing in rainy weather.
These overalls, especially designed to provide protection, are waterproof and breathable. Zipped fleece-lined pockets will be a shelter for your hands.
4 hours under heavy rain (> 10,000 mm). Fully taped seams. Water-repellent
Very breathable (RET<12).
Resistance to salt water
Injected plastic zipper.
3 secure pockets (2 fleece, 1 on the thigh).
Seat, knee and ankle reinforcements to resist wear.
Easy to use
Adjustable ankles, high cut for better chest protection.
- Dual-layer hydrophilic fabric
- >10,000 mm of water pressure.
- Fully taped seams.
- Inner flap
- Bottom of the legs adjustable by hook-and-loop fastener.
- Tested under a simulated heavy rain shower (450 L/hr/m²) for 4 hours.
RET < 12: very breathable.
To find out whether a fabric is breathable, we measure its evaporative resistance, or RET (test based on the ISO 11092 standard). It is its ability to allow the water vapour produced by the body during exercise to escape.
- The waist is adjustable using semi-elasticized hook-and-loop tabs.
A large reflective 3M patch on the back intensifies low light sources. The Tribord logos are also reflective.
RESISTANCE TO WEAR
- Injected plastic central zipper resistant to salt oxidation.
HOW TO REACTIVE THE JACKET'S WATER REPELLENCY \nstep 1: before washing
Close all zippers and flaps and remove any parts of the garment that cannot be washed. Also remember to loosen the straps and elastic parts and empty the pockets.
Then turn the garment inside out to wash it.
HOW TO REACTIVE THE JACKET'S WATER REPELLENCY \nstep 2: washing
You can wash your jacket on a synthetic cycle at 30° or 40°C with your usual detergent. Do not use bleach or fabric softener, which could damage the existing performance of the garment.
Also take care not to bend your jacket too much when you place it in the washing machine and do not overload your machine.
Very important: select a thorough rinse or double rinse to completely remove all detergent residue.
HOW TO REACTIVATE THE JACKET'S WATER REPELLENCY \nstep 3: drying
Drying is a crucial phase in reactivating the water-repellent treatment.
We recommend that you lay your jacket flat on a clothes rack and leave it out to dry in the open. Caution: never dry your jacket directly on a radiator.
Then place it in the tumble dryer on a short synthetics cycle, i.e. 10 to 15 minutes, before turning it right side out.
HOW TO REACTIVATE THE JACKET'S WATER REPELLENCY
If, despite this procedure of washing and thorough rinsing followed by gentle drying in a tumble dryer, the drops of water no longer run off the surface of your jacket, we recommend that you "re-waterproof" it using a spray sold in our stores.
Main fabric : 100.0% Polyamide\r\nMain lining : 100.0% Polyester\r\nSecondary lining : 100.0% Polyamide\r\nYoke : 100.0% Polyester
Store in a dry place, but do not leave your garment on a heat source such as a radiator, as this may damage the breathable membrane or coating.
Machine wash your Offshoroa waterproof and breathable overalls at 30°C. Inside-out with hook-and-loop strips stuck together. Choose a long rinse and gentle spin cycle. Line dry if possible. Occasional tumble drying on low for a short period of time will improve the water-repellent treatment. To reactivate the water-repellent treatment, you can also iron the fabric at a maximum temperature of 140°C or apply the Tribord re-waterproofing spray.
Men's Race Sailing Overalls reviews