Women's Sailing Oilskin 500 designed for regular inshore sailors (less than 15 days per year), in all weather conditions.
This long, waterproof and breathable women's jacket will provide long-lasting protection in bad weather, whether you are inshore sailing or just out and about.
4 hours under heavy rain (>10000 mm). Fully taped seams. Water repellent.
Salt water resistant
Injected plastic zipper. Treated coating.
Very breathable hydrophilic coating (RET=12)
One interior pocket and two hand-warmer zipper pockets. Two cargo pockets.
Cut, high collar and coated fabric to cut windchill.
Life cycle comparison: Women's waterproof jacket- sustainability.decathlon.com
- Dual-layer coating
- >10000 mm water pressure.
- Fully taped seams.
- Two-way adjustable hood.
- Sleeve cuffs adjustable by hook and loop fastener strips.
- Central opening features a flap with a drainage channel for optimal waterproofing.
- Tested under a simulated heavy rain shower (119 gal/hr/sqm) for 4 hours.
RET <12: very breathable.
Nylon/mesh lining to optimize perspiration wicking.
To find out whether a fabric is breathable, we measure its evaporative resistance, or RET, (test based on the ISO 11092 standard). It is its ability to allow the water vapor produced by the body during exercise to escape.
- Adjustable waist, built into the pockets.
- Two-way zipper.
RESISTANCE TO WEAR
- Treatment stopping the oxidation of the coatings.
- Zipper resistant to salt oxidation
Score to compare the environmental impact of products
The environmental impact of the product is calculated over its entire life cycle and with different indicators. An overall score (ABCDE) is attributed to help you easily identify the products with the best environmental performance by comparing products of the same type with one another (T-shirts, pants, backpacks, etc.).
Decathlon chose to apply this voluntary environmental labeling scheme.
For more information, visit: http://sustainability.decathlon.com/
HOW TO REACTIVATE THE JACKET'S WATER REPELLENCY? \nstep 1: before washing
Close all zippers and flaps and remove any parts of the garment that cannot be washed. Also remember to loosen the straps and elastic parts and empty the pockets.
Then turn the garment inside out to wash it.
HOW TO REACTIVATE THE JACKET'S WATER REPELLENCY? \nstep 2: washing
You can wash your jacket on a synthetic cycle at 86°F or 104°F with your usual detergent. Do not use fabric conditioner, which could damage the existing performance of the garment, or bleach.
Also take care not to bend your jacket too much when you place it in the washing machine and do not overload your machine.
Very important: select a thorough rinse or double rinse to completely remove all detergent residue.
HOW TO REACTIVATE THE JACKET'S WATER REPELLENCY? \nstep 3: drying
If, despite this procedure of washing and thorough rinsing followed by gentle drying in a tumble dryer, the drops of water no longer run off the surface of your jacket, we recommend that you "re-waterproof" it using a waterproofing spray or detergent sold in our stores.
Main fabric : 100.0% Polyamide \r\nMain lining : 100.0% Polyester cationic
Store in a dry place, but do not leave your garment on a heat source such as a radiator, as this may damage the breathable coating.
Machine wash your women's Inshoroa waterproof jacket at 86°F, inside out with the hook and loop fastener fastened and without fabric softener. Choose a long rinse and gentle spin cycle. Line dry if possible. Occasional tumble drying on low for a short period of time will improve the water repellent treatment. To reactivate the water repellent treatment, you can also warm iron the fabric (max. 230°F) or apply the Tribord re-waterproofing spray.