Women's Ski Pants 100

To help keep you warm, we use recycled padding insulation (2.1 oz/m²). This synthetic polyester-based padding traps more or less air, depending on the size of its fibers, to insulate you from the cold.

The coating is a waterproofing material spread over the inner surface of a fabric. It prevents water from seeping into the garment but allows the water vapor produced by the body's physical activity to escape. So you stay dry for greater comfort while practicing your sport.

The resistance of a fabric to water pressure is expressed in terms of the height in mm of a water column that can be supported by the fabric (test based on the ISO 811 standard). The higher the pressure, the more waterproof the fabric. A fabric with a waterproof rating of 3000 mm can therefore resist the pressure exerted by a 3000 mm column of water (roughly equivalent to a 2-hour downpour).

These pants have been developed using a robust component and rigorous assembly that limit wind chill and prevent the passage of water to help you brave all weather (rain, snow, wind, etc). To check their water-resistance, the pants were placed under a special shower, to reproduce the conditions faced by a skier. We have checked the waterproofness of this product in use in various weather conditions over several days.

The water-repellent property of a fabric is its capacity to allow water to run off its surface without seeping in. These pants feature water-repellent components to improve their resistance to bad weather. The fabric is made water-repellent by treating its outer surface. However, this property may deteriorate with use.

Remember that water repellency can be restored. To do this, put the pants in the dryer on a synthetics program for 10 to 15 minutes. You can also use a waterproofing spray (sold in our stores): spray the product evenly over the entire garment, then allow to dry for 10 to 12 hours).

It's a garment that is capable of wicking away the water vapor produced by your body when exercising. To see if a fabric is breathable, we measure its resistance to evaporative heat (RET) in a standardized ISO 11092 test. The lower the RET, the more breathable the fabric. The 150 pants have an RET of 7. However, it is the technical solutions (zippers, vents, mesh) that Wedze uses that limit the condensation inside the garment and maximize breathability.

To keep your legs warm and dry, you need 2 layers: 1 skiing base layer to wick away perspiration and 1 pair of ski pants to protect from the weather and provide warmth.

Regular fit with an internal volume that allows these pants to be combined with a technical base layer.

To optimize the performance and durability of your pants, we recommend: * Machine wash at 86°F, synthetics cycle. * Turn the product inside out. * Add a small amount of detergent. No fabric softener. * We recommend you wring it by hand. * Dry on a hanger in a warm, well-ventilated place. Do not dry-clean. Do not place on a radiator.

Imported

All Wedze products are conceived, designed and developed in the Mont Blanc Valley. They are then tested under the same conditions as you would experience in real-life use (snow, cold, powder snow, etc). The design teams make sure that the cycle for which the product is designed and developed corresponds perfectly to its use in the field.

Store on a hanger and do not fold, as this can damage the fabric coating. Dry thoroughly before storing in a dry and well-ventilated place.