Shaft: 100.0% Aluminium ; Handle: 100.0% Polyethylene

Fully designed and validated by our team.Why have we chosen the Push-pin? Some users do not want to make adjusting their poles more complicated than it needs to be. This system is simple, reliable, light and cheap.Why oversized tubes? Because this model is designed for walkers who need to be reassured about their reliability. Why a straight foam handle? Because our field tests have shown that comfort is better than with a plastic handle.

Hold the poles with your arms bent at a right angle.To do this: - pull the lower part until the lower push-pin locks;- slide the tube from the middle until the upper push-pin reaches the desired hole; - use the lines printed on the tubes to align the push-pin with the holes;Never go over the STOP line to avoid breaking the pole.

This hiking pole is designed to help you balance, propel yourself and distribute effort between arms and legs.To be on the safe side, check before you set off and at regular intervals that your baton is locked in place by simulating heavy bumps. Don’t put it on your backpack in a storm.Some users are sensitive to the whistling noise that can occur when the wind sweeps through the adjustment holes.

Proper maintenance of your baton will ensure that it functions optimally and that it lasts longer.After use, if water has penetrated the stick, remove the strands and allow to dry. If necessary, clean the dust or mud with water or a dry brush. Once dry, you can reassemble the strands.We recommend that you do not attempt to oil or grease the mechanisms.

At Decathlon, we have decided to sell our hiking/trekking poles individually. First because of how they are used. Indeed, some people only want to use one pole. Also, if one of your poles breaks, this means you only have to buy one and not a complete pair.

The advantage of buying Forclaz trekking poles is that you have a wide choice of compatible accessories and spare parts. So you can enjoy it for as long as possible.Hiking pole caps: ref. 8580865 Lower section MT100: ref. 8648384

To set our thresholds, we have measured the stresses on the poles in the most demanding situations. During the development phase, each model undergoes laboratory stress tests (compression, three-point bending, etc.) until they break. We also test parts separately (tightening power, tearing, etc.). Finally, these tests are regularly repeated in production to ensure a constant level of quality.

Store the baton in a dry place without tightening the adjusting systems, so that they are not strained and retain their clamping power.

Imported